EMAP-Wetlands: A sampling design with global application

The U.S. Environmental Protection Agency (EPA) initiated the Environmental Monitoring and Assessment Program (EMAP) in 1988. The wetland component (EMAP-Wetlands) is designed to provide quantitative assessments of the current status and long-term trends in the ecological condition of wetland resources. EMAP-Wetlands will develop a wetland monitoring network and will identify and evaluate indicators that describe and quantify wetland condition. The EMAP-Wetlands network will represent a probability sample of the total wetland resource. The EMAP sample is based on a triangular grid of approximately 12,600 sample points in the conterminous U.S. The triangular grid adequately samples wetland resources that are common and uniformly distributed in a region, such as the prairie pothole wetlands of the Midwest. However, the design is flexible and allows the base grid density to be increased to adequately sample wetland resources, such as the coastal wetlands of the Gulf of Mexico, which are distributed linearly along the coast. The Gulf sample network required a 49-fold increase in base grid density. EMAP-Wetlands aggregates the 56 U.S. Fish and Wildlife Service's (FWS) National Wetland Inventory (NWI) categories (Cowardin et al. 1979) into 12 functionally similar groups (Leibowitz et al. 1991). Both the EMAP sample design and aggregated wetland classes are suitable for global inventory and assessment of wetlands.The research described in this report has been funded by the U.S. Environmental Protection Agency. This document has been prepared at the EPA Environmental Research Laboratory in Corvallis, OR, through contract No. 68-C8-0006 to Man Tech Environmental Technology, Inc. This paper has been subjected to the Agency's peer and administrative review and approved for publication. Mention of trade names or commercial products does not constitute endorsement or recommendation for use.     

Confronting the challenges of discovery of novel antibacterial agents

Bacterial resistance is inevitable and is a growing concern. It can be addressed only by discovery and development of new agents. However the discovery and development of new antibacterial agents are at an all time low. This article broadly examines the historical as well as current status of antibacterial discovery and provides some perspective as how to address some of the challenges.     

Screening of rice cultivars for Cr-stress response by using the parameters of seed germination,morpho-physiological and antioxidant analysis

Rice is the most important crop for the majority of population across the world with sensitive behavior toward heavy metals such as chromium (Cr) in polluted regions. Although, there is no information on the Cr resistance phenotyping in rice. Herein, two different groups of rice cultivars (normal, and hybrid) were used, each group with 14 different rice cultivars. Firstly, seed germination analysis was conducted by evaluating various seed germination indices to identify the rice cultivars with greatest seed germination vigor. Furthermore, exposure of chromium (Cr) toxicity to 28 different rice varieties (NV1-NV14, HV1-HV14) caused noticeable plant biomass reduction. Subsequently, NV2, NV6, NV10, NV12, NV13 (normal type), HV1, HV4, HV8, and HV9 (hybrid types) were pragmatic as moderately sensitive varieties, while NV3, NV4, NV9, and NV14 (normal type), HV3, HV6, HV7, and HV13 were observed as moderately tolerant. Although, NV7, and HV10 were ranked most sensitive cultivars, and NV11, and HV14 were considered as most tolerant varieties as compared to the other rice (both groups) genotypes. Afterward, Cr induced reduction in chlorophyll pigments were significantly lesser in HV14 relative to NV11, NV7, and especially HV10, and as a result HV14 modulated the total soluble sugar level as well as reduced ROS accumulation, and MDA contents production by stimulating the antioxidant defense mechanism conspicuously which further reduced the electrolyte leakage as well. Our outcomes provide support to explore the Cr tolerance mechanism in cereal crops as well as knowledge about rice breeding with increased tolerance against Cr stress.     

Ethical Considerations for Outcome‐adaptive Trial Designs: A Clinical Researcher's Perspective

In a typical comparative clinical trial the randomization scheme is fixed at the beginning of the study, and maintained throughout the course of the trial. A number of researchers have championed a randomized trial design referred to as ‘outcome‐adaptive randomization.’ In this type of trial, the likelihood of a patient being enrolled to a particular arm of the study increases or decreases as preliminary information becomes available suggesting that treatment may be superior or inferior. While the design merits of outcome‐adaptive trials have been debated, little attention has been paid to significant ethical concerns that arise in the conduct of such studies. These include loss of equipoise, lack of processes for adequate informed consent, and inequalities inherent in the research design which could lead to perceptions of injustice that may have negative implications for patients and the research enterprise. This article examines the ethical difficulties inherent in outcome‐adaptive trials.     

Alginate embedding and subsequent sporulation of in vitro-produced Conidiobolus thromboides hyphae using a pressurised air-extrusion method

Conidiobolus thromboides is an entomophthoralean fungus with potential as a biological control agent of aphids. However, its application in biological control is limited due to its formulation requirements. The objective of this study was to develop and optimise a novel air-extrusion method to embed C. thromboides hyphae at high density in alginate pellets. An orthogonal experimental design was used to investigate selected combinations of parameters known to affect hyphal density within pellets. The diameter of pellets produced, and the calculated density of hyphae within them, ranged from 0.18 ± 0.09 to 3.17 ± 0.06 mm and from 0.02 to 350.56 mg/mm³ respectively. These data were used to predict the optimal parameter combination to deliver the greatest density of hyphae of C. thromboides per pellet: 1% sodium alginate, a 1:2 ratio of hyphae to sodium alginate, an orifice diameter of 0.232 mm and an air pressure of 0.05 MPa. Pellets made under the optimal conditions predicted produced a mean total of 4.3 ± 0.6 × 10⁵ conidia per pellet at 100% relative humidity which was significantly greater than the mean total number of conidia produced from infected aphid cadavers of comparable size (9.35 ± 0.85 × 10⁴) (p < 0.001). In conclusion, air-extrusion embedding appears to be a promising method for formulating in vitro-produced hyphae of C. thromboides for use in biological control.     

Construction of Partially Balanced Incomplete Block Designs with Nested Rows and Columns

A number of methods of construction of partially balanced incomplete block designs with nested rows and columns are developed and new balanced incomplete block designs with nested rows and columns are obtained as a by-product.     

CLIX: a search algorithm for finding novel ligands capable of binding proteins of known three-dimensional structure.

A computer algorithm, CLIX, capable of searching a crystallographic data-base of small molecules for candidates which have both steric and chemical likelihood of binding a protein of known three-dimensional structure is presented. The algorithm is a significant advance over previous strategies which consider solely steric or chemical requirements for binding. The algorithm is shown to be capable of predicting the correct binding geometry of sialic acid to a mutant influenza-virus hemagglutinin and of proposing a number of potential new ligands to this protein.     

Cervical screening in Luxembourg: 1990–1999

For quality assurance purposes, the results of the 1990's obtained by the National Cervical Cancer Screening Programme (NCCSP) launched in 1962 were reviewed. The positive cytodiagnosis, the histologically verified in situ and invasive cervical cancers and the mortality rates were reported.     

Introducing the Multivariate Dale Model in Population‐Based Genetic Association Studies

Until recently, the most common parametric approaches to study the combined effects of several genetic polymorphisms located within a gene or in a small genomic region are, at the genotype level, logistic regressions and at the haplotype level, haplotype analyses. An alternative modeling approach, based on the case/control principle, is to regard exposures (e.g., genetic data such as derived from Single Nucleotide Polymorphisms – SNPs) as random and disease status as fixed and to use a marginal multivariate model that accounts for inter‐relationships between exposures. One such model is the multivariate Dale model. This model is based on multiple logistic regressions. That is why the model, applied in a case/control setting, leads to straightforward interpretations that are similar to those drawn in a classical logistic modeling framework. (© 2004 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Do borderline nuclear changes in gynaecological cytlogy constitute a reliable reporting category?

Fourteen laboratories participated in a national slide exchange study to investigate whether borderline nuclear changes (BNC) constitute a reliable reporting category. Slides were submitted by participating laboratories, having achieved a 100% intralaboratory consensus at the primary screener, checker, and medical levels. Sets of seven slides were examined in laboratories for 1 week, and exchanges were undertaken over a 6-month period. Each laboratory was requested to submit three consensus opinions on each slide at the primary screener, checker, and medical levels.
Response patterns for submitted slides achieving a reporting category consensus at the 50 and 80% consensus levels indicated that negative, BNC, and mild dyskaryosis are distinct and comparable categories. Similarly, the two subcategories of BNC with or without human papillomavirus (HPV) are nearly as distinct as the overall BNC category.
The percentage of submitted slides achieving consensus at consensus levels between 50 and 80% produced variable findings with regard to the practical success of the main reporting categories. The negative category was reasonably successful, whereas mild dyskaryosis was consistently poor. Borderline nuclear changes were successful at the 50% consensus level but showed a rapid decline by the 65% consensus level. The reason(s) for this remains speculative but indicates a possible potential of BNC to work successfully with additional training and education.
Reporting practices were not consistent among the laboratories and differences were identified between medical and nonmedical staff. A high use of the BNC category was noted in slides that failed to achieve consensus. A national study assessing all grades of abnormalities would appear essential.